The maintenance of automatic feeding mixer can not be ignored. If properly maintained, not only can improve work efficiency, but also can extend the service life of independent mixer. Therefore, let's take a look at the maintenance requirements of today's Xiaobian automatic feeding mixer.

1.自动上料搅拌机将定期清洁燃油系统并控制积碳的产生，以使发动机保持良好状态。

1. The automatic feeding mixer will clean the fuel system regularly and control the generation of carbon deposit to keep the engine in good condition.

2.为自动上料搅拌使用适当质量等级的油。对于发动机，应根据以下条件选择SD-SF级发动机油：进气和排气系统的附加设备和运行条件；柴油机应根据机械负荷使用CB-CD级柴油。选择规格基于不少于制造商的规定。

2. Use oil of appropriate quality grade for automatic feeding mixing. For engines, sd-sf grade engine oil should be selected according to the following conditions: additional equipment and operating conditions of intake and exhaust system; The diesel engine should use cb-cd diesel according to the mechanical load. The selected specifications are based on not less than the manufacturer's specifications.

3.搅拌机的机油和滤芯将定期更换。在任何质量等级的运行过程中，机油质量都会发生变化。为了防止出现问题，应根据使用条件定期更换机油，并且机油的用量应适中（通常是润滑脂的上限）。

3. The engine oil and filter element of the mixer will be changed regularly. The quality of engine oil will change during the operation of any quality level. In order to prevent problems, the oil should be changed regularly according to the service conditions, and the amount of oil should be moderate (usually the upper limit of grease).

4.设备齐全的搅拌机坚持曲轴箱的良好通风。

4. The mixer with complete equipment should adhere to the good ventilation of the crankcase.

5.搅拌机的保养。三种滤清器：三种滤清器是指空气滤清器，机油滤清器和燃油滤清器。当今的大多数发动机都装有PCV气门（曲轴箱强制通风），但是氦气中的污染物会沉积在PCV气门周围，这可能会阻塞气门。因此，必须定期清洁PCV阀周围的污染物。

5. Maintenance of mixer. Three filters: three filters are air filter, oil filter and fuel filter. Most of today's engines are equipped with PCV valves (positive crankcase ventilation), but contaminants in helium will deposit around the PCV valves, which may block the valves. Therefore, contamination around the PCV valve must be cleaned regularly.

6.搅拌机会定期清洁曲轴箱。

6. Clean the crankcase regularly.

在发动机运转期间，焚化炉中的高压未燃烧气体，酸，水分，硫和氮氧化物将通过活塞环和气缸壁之间的间隙进入曲轴箱，并与燃烧产生的金属粉末混合。零件磨损。污泥。因此，应定期清洁曲轴箱，以保持发动机内部清洁。

During engine operation, the high pressure unburned gases, acids, moisture, sulfur and nitrogen oxides in the incinerator will enter the crankcase through the gap between the piston ring and the cylinder wall and mix with the metal powder produced by combustion. Wear of parts. Sludge. Therefore, the crankcase should be cleaned regularly to keep the engine clean.

7.搅拌机的发动机机油箱生锈和结垢是更常见的问题。铁锈和水垢会限制冷却液在冷却系统中的移动，降低散热效果，导致发动机过热，甚损坏发动机。因此，必须定期清洁水箱，以水箱之间的锈蚀和水垢。

7. Rust and scaling are more common problems in the engine oil tank of mixer. Rust and scale will limit the movement of coolant in the cooling system, reduce the heat dissipation effect, cause engine overheating, and even damage the engine. Therefore, the water tank must be cleaned regularly to remove the rust and scale between the water tanks.