Due to the characteristics of the equipment, automatic feeding mixers are widely used in various buildings. Long term use of the equipment will inevitably cause various failures. Most of them have been blocked, but what should we do if such problems occur in the device?
Before each charging, flush the water inlet with water to keep the water inlet wet during the water inlet process.
During loading, fill the washing water tank installed on the vehicle with water. After charging, flush the inlet and clean the concrete near the inlet.
After unloading at the construction site, wash the unloading box, and then add 30-40L of washing water to the concrete storage box. Keep the concrete tank rotating slowly during vehicle return.
Before the next loading, please remember to drain the sewage from the concrete tank.
Clean the inlets and outlets around the concrete tanks and machines in a timely manner every day. The cleaning point of automatic feeding mixer can prevent cement and concrete from caking.
In addition, if the automatic feeding mixer shuts down during transportation, most of it is caused by the blockage of the pipeline, but there is also a non blocking suspension, what should we do? At this time, slow down the conveying. Use the residues in the tank for slow transportation; In the process of conveying, it is necessary to find the interrupted part and stop the conveying; If it is summer, the interruption time shall not exceed one hour. In the process of using the automatic feeding mixer, attention should be kept at all times to avoid machine damage and construction period delay caused by operational errors.
The above knowledge is about the handling steps when the automatic feeding mixer is blocked. Here, we need to remind everyone that they need to do a good job in equipment maintenance and repair to avoid equipment failure. Follow us http://www.zkhntjbj.com , let you know more about the mixer!