In the process of construction, many enterprises work continuously and efficiently in order to improve their own interests. If the equipment is repaired due to failure, it will increase a lot of costs. In general, the wear of parts is common during the operation of the automatic feeding mixer. What should we do to avoid this?
1. Maintain the rated load of automatic feeding mixer
The load nature and size of such construction machinery equipment have an important impact on the wear of equipment parts. Generally, the wear of mechanical parts will increase with the increase of load. When the load borne by the parts is higher than the designed working load, the wear of their components will continue to increase.
2. Clean in time to reduce the impact of mechanical impurities on equipment
Mechanical impurities generally refer to dust, soil and other substances, as well as some metal chips and oil dirt produced by construction machinery during use. Once these impurities reach between the working surfaces of the machine, they will do great harm: not only increase the friction, but also increase the fuel consumption. Moreover, the lubricating oil film will be damaged and the mating surface will be scratched.
3. Prevention of Parts Corrosion of Automatic Feeding Mixer
The corrosion effect on the parts is sometimes difficult to be found, easy to be ignored, and more harmful. Rainwater, chemical substances in the air, etc. penetrate into the machinery through the pipes and gaps of mechanical parts, corroding the parts. If the corroded parts continue to work, the mechanical wear will be accelerated and the mechanical failure will be increased. This requires managers and operators to take reasonable construction arrangements according to the local weather conditions and site conditions at that time, so as to minimize the harm of chemical corrosion to mechanical parts.
4. Maintain reasonable temperature of equipment parts of automatic feeding mixer
During operation, the temperature of each component has its own normal range. If the temperature is too high or too low, the strength of parts will be affected. Therefore, it is necessary to cooperate with the coolant and lubricating oil to control the temperature of some parts, so that they can work within a reasonable temperature range.
Many mechanical equipment are caused by wear of parts at the beginning of failure, and the same is true of automatic feeding mixer during operation. Therefore, reducing the wear of equipment parts in the use process can effectively avoid the failure of mechanical equipment in the use process. Follow us http://www.zkhntjbj.com Take you to learn more about relevant matters!