As the main machine structure of the concrete mixing plant, the automatic feeding mixer plays a decisive role in the mixing plant. Therefore, it is very important to grasp the production efficiency of the automatic feeding mixer. Now, let's talk about how to effectively improve the working efficiency of the automatic feeding mixer?
Grasp the correct operation mode of automatic feeding mixer
Operators shall operate in strict accordance with the safety regulations. Before work, check whether the clutch and brake are flexible and reliable, whether the steel wire rope is broken and damaged, and whether the protective devices are complete and reliable, and conduct a test run; If the mixing drum rotates smoothly, does not jump, does not deviate, the hopper up and down and the discharge door rotate flexibly, and the cam mechanism under the hopper is normal, it can work.
Maintain the automatic feeding mixer
Maintain the cleanness of the automatic feeding mixer body, and remove the dirt and obstacles on the body. Check the oil, circuit and control equipment at each lubricating place, and fill the lubricating oil as required. Before each shift, fill the mixing drum with water and idle for 1 to 2 minutes, and check the reliability of the clutch and braking device at the same time.
During the operation of the automatic feeding mixer, you should always check whether the noise of the motor, reducer and transmission gear is normal and whether the temperature rise is too high. After each shift, the automatic feeding mixer should be carefully cleaned.
In addition, the corresponding inspection work should also be done well, such as checking the main mixing equipment and checking whether there is abnormal noise in the concrete mixer; Whether the oil output of the butter pump is normal, whether the oil level of the reducer is normal, and whether there is oil leakage; Whether the door opening mechanism is flexible and whether there is slurry leakage; Whether the transmission mechanism is normal. Problems should be registered and repaired in time.
Secondly, whether the actuator, cylinder and valve operate normally and whether there is air leakage; Whether the inlet and outlet soft connections of each metering bucket are damaged or leaked; Whether the water scale and admixture scale have overflow phenomenon; Whether the valve plate of the intermediate waiting silo is worn, and whether the lining plate of the concrete discharge hopper is damaged. If any damage is found, it should be replaced in time.
How to effectively improve the working efficiency of the automatic feeding mixer? Grasp the correct operation mode of the automatic feeding mixer, and do a good job in the maintenance and daily inspection of the automatic feeding mixer. For more relevant content, please visit the website http://www.zkhntjbj.com Consult and understand.