Speaking of the maintenance of the all-in-one mixer, the maintenance of the chassis is easy to be ignored by drivers, but the importance of chassis maintenance is obvious in winter or wet weather. Now let's talk about the first-aid measures for the damage of the chassis parts of the all-in-one mixer.
When the chassis components of the all-in-one mixer are damaged on the site or far away from the maintenance site, the following first-aid methods can be used to drive the vehicle to the maintenance site according to different fault conditions.
If the brake cylinder leaks brake fluid or the cylinder pipe is broken, you can make a small cushion with iron sheet or copper sheet at the cylinder barrel joint to block the pipe, and then tighten the screws, or flatten the broken part and curl the blockage, so that the wheel can not be used for braking. But doing so may cause unilateral braking, so pay attention to safety when driving.
The brake master cylinder of the all-in-one mixer is short of brake fluid, which can be replaced by alcohol or Baijiu, and water can be used under special circumstances. After the brake cup expands, soak the expanded cup in hot water for 10-20 minutes to remove the oily components on the cup and restore the cup to its original size.
When maintaining the chassis of the mixer in winter, the chassis must be thoroughly cleaned to prevent rust. The concrete base plate shall be thoroughly cleaned. If there is too much soil on the chassis, it should be cleaned with degreasing detergent to expose the original "true color" of the chassis, so as to start rust prevention care.
In a professional beauty shop, you can lift the all-in-one mixer onto the lifting frame for chassis cleaning, wiping, and then rust prevention care. It should be noted that after cleaning, you must wait until the moisture on the chassis is dry before rust prevention care can be carried out.
When nursing, be sure to maintain a uniform spraying layer to form a uniform, rust proof and durable coating. After all, let it dry naturally for 5-10 minutes, and the rust prevention treatment of the chassis is completed.
There is a misunderstanding, that is, people often wash the car for the all-in-one mixer, which often adds some detergent. At this time, please be careful not to use alkali. Use detergent, washing powder, etc. to clean the car body and chassis, otherwise it will affect the antirust effect and shorten the antirust time. Come to the website for more relevant content http://www.zkhntjbj.com Consult!